Files
Joas Antonio dos Santos 0389706606 tipc: raise the minimum bearer MTU to fit tunnel and crypto overhead
A peer can lower the link MTU to TIPC_MIN_BEARER_MTU (100 bytes, plus
the UDP encapsulation header) with the max_pkt field of a RESET or
ACTIVATE message; tipc_link_proto_rcv() only checks the lower bound
returned by tipc_bearer_min_mtu().  The same bound is applied to the
device MTU when a bearer is enabled.

That bound predates two later reductions of the link MSS:

  tipc_link_mss() = mtu - INT_H_SIZE                    (tunnel header)
                         - EMSG_OVERHEAD               (CONFIG_TIPC_CRYPTO)

With CONFIG_TIPC_CRYPTO=y, which is the default, an MTU of 100 gives an
MSS of 28.  Once the link comes up, tipc_named_node_up() calls
named_distribute(), which computes

  msg_dsz = ((tipc_node_get_mtu() - INT_H_SIZE) / ITEM_SIZE) * ITEM_SIZE;

For an MSS of 28 the subtraction is negative and the result truncates to
0xfffffff0; for an MSS between 40 and 59 it is 0.  named_prepare_buf()
then allocates a buffer with no room for any item (the u32 size wraps),
and msg_rem never reaches zero, so every cluster-scope publication on
the node is written with publ_to_item() past the end of that one skb,
over skb_shared_info and into adjacent memory.

Without crypto the MSS is at least 60, which still does not hold the
first fragment built by tipc_msg_build(): INT_H_SIZE fragment header
plus a message header of up to MAX_H_SIZE.  With pktmax below that, the
header copies run past the pktmax bytes allocated for the fragment.

Raise TIPC_MIN_BEARER_MTU to MAX_H_SIZE + 2 * INT_H_SIZE so the MSS can
always hold INT_H_SIZE + MAX_H_SIZE, which also leaves room for name
table items, and add tipc_bearer_mtu_floor(), which adds EMSG_OVERHEAD
on top for CONFIG_TIPC_CRYPTO=y.  Use it for the device MTU check
(tipc_mtu_bad()), the UDP MTU check, the netlink MTU setting and
tipc_bearer_min_mtu(), which also bounds the max_pkt negotiation.

Found by manual code review and reproduced with KASAN using two network
namespaces joined by a veth pair (see below).

Fixes: fc1b6d6de2 ("tipc: introduce TIPC encryption & authentication")
Fixes: 2320bcdae6 ("tipc: fix changeover issues due to large packet")
Suggested-by: Tung Nguyen <[email protected]>
Signed-off-by: Joas Antonio dos Santos <[email protected]>
Reviewed-by: Tung Nguyen <[email protected]>
Link: https://patch.msgid.link/[email protected]
Signed-off-by: Paolo Abeni <[email protected]>
2026-11-04 15:55:53 +01:00
..
…
…
…
…
…
…
…
…
…
…